Subscribe to:
Post Comments (Atom)
13. Clear your work area and your escape path of brush, vines, and other hazards that can trip you or catch your saw.
14. Escape from the bullseye when the tree tips. 90% of accidents happen within 12 feet of the stump. Go more than 15 feet, and stay out of the bullseye until things stop falling.
15. Keep spectators away more than twice the height of the tree in the direction it will fall.
16. Don't cut alone.
17. Keep your body and the swamper's out of the line of the bar in case of a kickback.
18. Set the brake when taking over two steps or when moving through tripping hazards. Keep your trigger finger off of the throttle when you are moving.
19. DO NOT operate a chainsaw from a ladder! Operating with your feet off the ground requires special training.
20. Do not cut above your shoulders.
21. Springpoles must be shaved on the inside of the apex between the ascending and descending sides. If the apex is higher than you shoulders, stand under the springpole and cut it low on the descending side. It will release upward, away from you.Leaning and heavily loaded poles that are too small to bore cut for a hinge should be shaved on the compressed side until they fold.
22. Do not cut a tree that is holding up a lodged tree. Do not work under a lodged tree. Think about a mouse trying to steal the cheese out of a trap.
23. Instruct your swampers and helpers to NEVER approach you from behind or the sides to within the reach of your saw when you are cutting. If you pull out of a cut with the chain running, or have a severe kickback, the swamper can be killed if he is coming up behind you!
24!! Quit When You Are Tired!
4 comments:
UMMM, that's going to take some serious cleaning, unless you like iron (oxide) in your coffee :)
Merle
PS: are you going to use this one?
We have a little one like this that has ground coffee for decades. It's good for waking company in the morning. I think these were mostly used for cracking corn for chicken feed, but they handle coffee beans just fine. Currently we are using a vintage Kitchen-Aid electric grinder that must be around 60 years old. I need to video that.
Yeah, now I wish I had retrieved Grandma's hand powered coffee grinder when she replaced it with electric!
Off to the dump it went, along with the four post Maytag wringer-washer that was originally gasolene powered.
If only I had been smart enough to recognize those future antiques.....
Merle
Oh, ain't it the truth! Some antiques are precious, others are better left alone. I don't want any blowtorches amongst my collectibles. Wear on the bottom rim can allow the bottom to blow out when you pump it up, and then you have a firebomb at your feet. I know of one death from that, and that's enough for me. Un-guarded tumble rods and gears have my never ending respect, and few youngsters today realize the dangers of contact with them. Watch your grandkids at the gas engine shows.
Post a Comment